Difference between revisions of "WiFi Module"
(The WiFi module might deserve it's own documentation) |
(There's a lot going on with this little module) |
||
| Line 1: | Line 1: | ||
| − | + | DSi DWM-W015 | |
| − | If this module is disconnected | + | The DSi WiFi module actually contains two wireless chips, a Mitsumi MM3218 for DS compatibility and a more modern Atheros AR6002G, which share the antenna through an RF switch. The DS WiFi is configured through profiles 1-3 and is limited to 802.11b 1-2Mbps and WEP encryption while the Atheros supports 802.11g rates and WPA encryption, configured through profiles 4-6. |
| + | |||
| + | The Mitsumi WiFi is controlled through data in the NVRAM (eg: Region code) http://www.daftcode.net/gbatek/ds#dsfirmwarewificalibrationdata while the Atheros appears to have it's configuration stored elsewhere. | ||
| + | |||
| + | If this module is disconnected the DSi turns on to a black screen, presumably because it can't read the NVRAM. If the DSi doesn't like the data contained on the module it will give either error 0000FEFE or 0000FE00 at poweron. | ||
picture of a rev0 WiFi module | picture of a rev0 WiFi module | ||
http://www.flickr.com/photos/micahdowty/3846960965/sizes/o/in/photostream/ | http://www.flickr.com/photos/micahdowty/3846960965/sizes/o/in/photostream/ | ||
| − | + | There are at least two hardware versions of the module, the original using a 1Mbit SPI flash ST M45PE10 [[Media:STM45PE10.pdf]] and a newer version which I had using a very tiny chip labeled "5A32" and I think "8936" but it might be "B936". Note the circle in this image shows a 10k resistor from pin 5 WP to GND, which the ST M45PE10 datasheet indicates will write-protect the first 64K. If you would like to disable this protection, remove the resistor and solder pin 5 to pin 6 VCC. | |
| − | + | [[Image:DWM-W015a.jpg]] | |
| − | |||
| − | |||
| − | |||
| − | + | khmann had success backing up the 5A32 using the above pictured connection to a DS cartridge, removing the 5A32 and installing a ST M45PE20 2Mbit SPI flash salvaged from said NDS game with said data. not sure what this "gets you" yet... but theorized that this change might have something to do with newer DSi units unable to use the CookingCoach dslink exploit | |
Revision as of 15:21, 24 August 2012
DSi DWM-W015
The DSi WiFi module actually contains two wireless chips, a Mitsumi MM3218 for DS compatibility and a more modern Atheros AR6002G, which share the antenna through an RF switch. The DS WiFi is configured through profiles 1-3 and is limited to 802.11b 1-2Mbps and WEP encryption while the Atheros supports 802.11g rates and WPA encryption, configured through profiles 4-6.
The Mitsumi WiFi is controlled through data in the NVRAM (eg: Region code) http://www.daftcode.net/gbatek/ds#dsfirmwarewificalibrationdata while the Atheros appears to have it's configuration stored elsewhere.
If this module is disconnected the DSi turns on to a black screen, presumably because it can't read the NVRAM. If the DSi doesn't like the data contained on the module it will give either error 0000FEFE or 0000FE00 at poweron.
picture of a rev0 WiFi module http://www.flickr.com/photos/micahdowty/3846960965/sizes/o/in/photostream/
There are at least two hardware versions of the module, the original using a 1Mbit SPI flash ST M45PE10 Media:STM45PE10.pdf and a newer version which I had using a very tiny chip labeled "5A32" and I think "8936" but it might be "B936". Note the circle in this image shows a 10k resistor from pin 5 WP to GND, which the ST M45PE10 datasheet indicates will write-protect the first 64K. If you would like to disable this protection, remove the resistor and solder pin 5 to pin 6 VCC.
khmann had success backing up the 5A32 using the above pictured connection to a DS cartridge, removing the 5A32 and installing a ST M45PE20 2Mbit SPI flash salvaged from said NDS game with said data. not sure what this "gets you" yet... but theorized that this change might have something to do with newer DSi units unable to use the CookingCoach dslink exploit